Current Probes 20 Hz - 500 MHz
Current Probes are designed to be used in the process of generating and measuring high levels of RF current for a wide variety of industrial and scientific applications. Conducted currents can be measured without making direct contact with the source conductor or metallic surface. These EMC Current Probes are designed to permit field intensity meters, spectrum analyzers, and other 50-ohm impedance instruments to measure quantitative magnitudes of current. Measurements can be made on single and multi-conductor cables, ground and bonding straps, shielded conduits and on coaxial cables.
View a comparison of the specifications for our RF current probes.
Monitoring Current Probes 20 Hz - 500 MHz
BCP-610
20 Hz - 20 MHz
This current probe measures currents on 50 Hz, 60 Hz and 400 Hz powerlines andhas a usable frequency range of 20 Hz - 20 MHz.
BCP-611
10 KHz - 150 MHz
This probe is capable of measuring pulse currents up to 100 amperes with wide operating frequency of 10 KHz - 150 MHz.
BCP-614
10 KHz - 300 MHz
This probe is capable of measuring pulse currents up to 100 amperes with wide operating frequency of 10 KHz - 300 MHz.
BCP-615
10 KHz - 500 MHz
This probe is capable of measuring pulse currents up to 100 amperes with wide operating frequency of 10 KHz - 500 MHz.
BCP-616
10 KHz - 150 MHz
This probe is capable of measuring pulse currents up to 100 amperes with wide operating frequency of 10 KHz - 150 MHz.
BCP-618
100 KHz - 500 MHz
This probe can be used to measure small RF currents in the basic configuration and pulse currents with wide ranging magnitudes.
BCP-619
100 Hz - 100 MHz
This probe can be used to measure small RF currents in the basic configuration and pulse currents with wide ranging magnitudes.
BCP-620
10 KHz - 500 MHz
MIL-STD 461 CS114 Current Probe used to measure RF currents and pulse currents with wide ranging magnitudes.
Injection Current Probes 10 KHz - 500 MHz
ICP-621
10 KHz - 100 MHz
This injection current probe can be used as injection source as well as a sensitive monitoring probe.
ICP-622
1 MHz - 500 MHz
This injection current probe is used to couple large RF currents into signal and power circuits to meet specific testing requirements. MIL-STD 461.
Current Probe Fixtures 20 Hz - 1 GHz
CPF-630
20 Hz - 500 MHz
Most Bulk Current Injection Test Procedures require the use of current probe fixtures.
CPF-632
20 Hz - 500 MHz
Small diameter current probe fixture.
CPF-633
20 Hz - 500 MHz
Large diameter current probe fixture.