Standard Gain Horn Antenna

Model: SAS-582-10

2.6 GHz to 3.95 GHz

This Standard Gain Horn Antenna will provide reliable, repeatable measurements. An ideal solution and a standard workhorse of any EMC test house for compliance testing.

Features

2.6 GHz to 3.95 GHz
Individually Calibrated at 1 & 3 Meter Horizontal Polarity
FCC, MIL-STD, CISPR and TEMPEST Testing
Rugged Construction
Three Year Warranty

Datasheet Manual

Product Description

The Standard Gain Horn Antennas are designed specifically for utilization in emissions and immunity testing over the frequency range of 1 to 40 GHz. Each antenna is linearly polarized and has medium gain, low VSWR, and a constant antenna factor. The Standard Gain Horn performance is very precise and predictable through design parameters. Comparisons of measured versus computed antenna factors and gain have been shown to be +/- .5 dB. Therefore, the antenna is considered to be a standard reference, similar to that of a resonant dipole below 1 GHz. The coax-to-waveguide adapter is the only power-limiting component on the antenna and can be removed if high fields are desired. Each Standard Gain Horn comes with a tripod mount that adapts to any tripod with 1/4-20 male threads. Horizontal and vertical polarization is obtained by rotating the antenna on the tripod.

Included parts:

SAS-582-10 Antenna with attached waveguide to coax adapter and tripod mount
Antenna Calibration Manual

* Calibration data and certificate at 1 and 3 meter horizontal polarity included

Specifications

Frequency Range:	2.60 GHz - 3.95 GHz
Antenna Factor (1 meter)	28 to 32 dB/m
Gain	10 dBi
Maximum Continuous Power:	250 Watts
Beamwidth E-plane	50°
Beamwidth H-plane	54°
Impedance:	50 ohm
VSWR:	1.25:1 (1.5:1 max)
Connector:	WR-284 to N-Type female adapter

Physical Dimensions:
Length	10.5 in. (27 cm)
Width:	3.5 in. (9 cm)
Height:	4.7 in. (12 cm)
Weight:	3 lbs. (1.4 kg)

The information provided below is for general informational purposes only and should not be relied upon for any specific purpose.

Plastic Tripod

ATU-514

The ATU-514 is a collapsible tripod is built with all non-metallic materials that will not influence your antenna measurements.

ATU-514

Product Details

Az and El Head

AEH-510

The AEH-510 Azimuth and Elevation head is used to assist the test engineer in pointing the mounted test antenna towards the device under test. This adjustable antenna mount has a rugged 4" mounting surface with a Captive 1/4-20 male thread for mounting all of A.H. Systems and most other compliance measurement antennas.